Know the connector parts:
Step 1: Strip the Cable
The above length is the suggested stripped length for the outer jacket and the inner wires.
Step 2: Put the Cable into the Connector Parts.
Step 3: Use the screw driver to screw down the nuts to lock the conductor of the wires tight.
Suggest Torque: 0.8+/-0.1N·m (For torque screwdriver.)
Step 4: Screw the housing of the connector with the body of the connector, as tight as possible.
Step 5: Use the Wrench to screw the nut with the housing of the connector. (Regular Monkey Wrench is OK, too.)
Suggest Torque: 2.0+/-0.5N·m (For Torque wrench)
Step 6: Do the same for the Male Parts, and screw the Male Connector with Female Connector as tight as possible.